31
Battery mode:
When the UPS is operating during a power outage the alarm beeps once every
four seconds and the LCD display string shows “bATT” to indicate the UPS is
working from the batteries. If the battery’s capacity becomes low whilst in
Battery mode the alarm beeps once every second and the LCD display string
shows “bATL”.
Standby mode:
When the UPS is turned off but remains plugged into the mains supply, the
UPS is in Standby mode. The LCD display string shows “STbY” to indicate that
power is not available to your equipment. The battery recharges when
necessary.
4.3 Configuring load segment
The Load Segment is a set of C13/C19 ports that can be controlled through
the LCD display. Each UPS has two configurable load segments. See “Rear
Panels” on pages 39 - 40 for images which show all connections on the back
of the UPS including the load segment (AC Outputs).
Note: This setting can be altered whilst the UPS is switched on.
To configure the load segment through the display:
1.
Enter settings mode: Press and hold the Enter button
for longer than 3
seconds. This will cause the UPS to go into settings mode.
