32
2.
Select settings item: Press the Select button
to cycle through the setting items shown in Table 5.
3.
Enter settings item: When the LCD displays “LS1” or “LS2”, press the enter
button
for longer than one second to enter LS1 or LS2 settings this will
cause the settings string to flash.
4.
Select setting value: Press the Select button
to select the settings value.
Select the value [001] to turn on that load segment or select [000] to turn off
that load segment.
5.
Confirm settings: Press and hold the Enter button
for one second, and the
UPS will then return to settings mode.
6.
Exit Settings mode: Press and hold the Enter button
for 3 seconds or the
power button
for 0.5 second to exit settings mode
4.4 Configuring UPS for EBM numbers
To ensure the LCD displays the correct battery capacity, configure the UPS for
the correct number of EBMs:
1.
Enter settings mode: Press and hold the Enter button
for longer than 3
seconds. This will cause the UPS to go into the settings mode.
2.
Select settings items: Press the Select button
to cycle through the settings
until you reach the settings item “EbM”.
3.
Enter settings item: Press the Enter button
for longer than one second to
enter the setting item.