C400R User Manual
Page 11
INSTALLATION
•
DO NOT
connect the UPS to a mains supply until installation is completed
•
Ventilation of the UPS is important for proper operation. Ensure the air vents on the front, side and rear of the
UPS are clear. Allow adequate space around the UPS. The airflow diagram is shown as below:
Installation considerations:
•
The final location of the UPS unit must be on a flat stable surface in a well-ventilated environment
•
DO
keep at least 150mm of free space behind the rear panel
•
If installing an additional unit, place it next to the first unit in its final location
•
DO
allow the UPS to reach ambient temperature before turning on
•
The UPS needs to be fully charged to achieve full autonomy
C400R TOWER MODEL INSTALLATION
Tools required:
•
Insulated screwdriver
•
Box Contents
STEP ONE
Ensure utility power is switched off.
STEP TWO
Carefully place the UPS within the stands.
STEP THREE
Pull out the LCD panel and carefully rotate it taking care not to damage the cable.
STEP FOUR
If not installing additional EBMs skip to step six
Position the UPS and External Battery Modules (EBM) within the extended UPS stands then slide the stands to either end of the tower
finally, on top of the units screw in the joining plate provided for extra stability.
DO NOT MAKE ANY UNLICENSED MODIFICATIONS TO THE UPS. THIS MAY INCUR DAMAGE AND AFFECT THE UPS
WARRANTY.
A QUICK START VIDEO GUIDE FOR THE C400R TOWER MODEL IS AVAILABLE AT