1. Roll out the 12 V cord and connect the 12 V adapter to the vehicle’s 12 V
outlet.
2. Screw the thread connection onto the tire’s valve stem.
3. Operate the air compressor until the desired pressure is reached (press the
button switch to turn on the compressor and press again to turn it off).
4. Remove the thread connection from the tire and disconnect the 12 V car
adapter.
1. Roll out the 12 V cord and connect the 12 V adapter to the vehicle’s 12 V
outlet.
2. Screw the ball/balloon adapter into the thread connection.
3. Insert the ball/balloon adapter into the valve of the object to be inflated.
4. Operate the air compressor until the desired pressure is reached (press the
button switch to turn on the compressor and press again to turn it off ).
5. Remove the ball/balloon adapter from the inflated object’s valve and unscrew
ball/balloon adapter from the thread connector. Put the ball/balloon adapter
back in the storage compartment.
6. Disconnect the 12 V car adapter from the outlet and store the 12 V cord in
the compartment area underneath.
7. Note: if a pressure reading is required during inflation, the built-in pressure
gauge will provide an approximate reading only.
To avoid over-inflation of tires, please check the recommended car tire pressure
in the vehicle owner’s manual or on the vehicle placard located in the driver’s
door panel. For bicycle tires, please check the tire marking.
NOTE
Do not over inflate objects. Over inflation could cause damage and/or personal
injury. Do not leave inflator unattended during use. Allow inflator to cool for 10
minutes after 10 minutes of continuous operation. Read instructions before use.
CAUTION
OPERATION
Inflating tires and bicycle tires
Inflating sporting equipment (i.e. basketball) or
party balloons
3
