6
model no. 060-0740-4
AWG, 14 AWG or 12 AWG extension
cords should be used. An undersized
cord will cause a drop in line voltage
resulting in loss of power and
overheating. (NOTE: Table 1 shows
the correct size to use depending
on cord length and nameplate
ampere rating. If in doubt, use the
next heavier gauge. The smaller
the gauge number the heavier the
cord.) To reduce the likelihood of
disconnection of lawn mower cord
from the cord set during operating:
i) Make a knot as shown in Figure 1,
or
iI) Use one of the plug-receptacle
retaining straps or connectors
described in this manual.
10) Don’t abuse cord - Never pull
lawn mower by cord or yank it to
disconnect from receptacle. Keep
cord from heat, oil, and sharp edges.
11) Don’t force lawn mower - It will do
the job properly and safer at the
rate for which it was designed.
12) Don’t overreach - Keep proper
footing and balance at all times.
13) Stay alert - Watch what you are
doing. Use common sense. Do not
operate lawn mower when you are
tired.
14) Disconnect lawn mower -
Disconnect the lawn mower from
the power supply when not in use,
before servicing, when changing
accessories such as blades, and the
like.
15) Store idle lawn mower indoors -
When not in use, lawn mower should
be stored in an indoor dry and
locked-up place - out of reach of
children.
16) Maintain lawn mower with care -
Keep cutting edges sharp and clean
for best and safest performance.
Follow instructions for lubricating
and changing accessories. Inspect
lawn mower cord periodically and
if damaged, have it repaired by an
authorized service facility. Inspect
extension cords periodically and
replace if damaged. Keep handles
dry, clean, and free from oil and
grease.
17) Keep guards in place and in working
order.
18) Keep blades sharp.
19) Keep hands and feet away from
cutting area.
20) Objects struck by the lawn mower
blade can cause severe injuries to
persons. The lawn should always be
carefully examined and cleared of
all objects prior to each mowing.
21) If lawn mower strikes a foreign
object, follow these steps:
i) Stop lawn mower. Release the
switch.
ii) Unplug power cord.
iii) Inspect for damage.
iv) Repair any damage before
restarting and operating the lawn
mower.
22) Use identical replacement blades only.
Table 1
Minimum gauge for extension cords
Ampere
rating
Volts
Total length of cord
120V
25’
50’ 100’
150’
7.2 m 15.2 m
30.4
m
45.7 m
more
than
not
more
than
AWG
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
NOTE- Only the applicable parts of the Table
need to be included
SAFETY INFORMATION
Summary of Contents for 060-0740-4
Page 2: ...2 model no 060 0740 4 CANADA 1 844 428 7277 ...
Page 30: ......
