18
model no. 060-0750-0 I contact us: 1-844-428-7277
To clean a flooded engine
NOTE:
if the engine won’t start after you have pressed the starter several times, the
engine may be flooded with excess fuel. Use following procedure to clear and start a
flooded engine.
1. Release the operator presence control bar to stop engine.
2. Remove the spark plug, dry it, and then re-
install it.
(1) Remove the spark plug cover (see Fig. 18).
(2) Use the spark plug socket wrench
(supplied) to remove the spark plug (see
Fig. 18-1).
(3) After drying, replace the spark plug.
NOTE:
Install the spark plug carefully by hand to avoid cross-threading. After the plug is
seated, tighten 1/8 to 1/4 turn with the spark plug socket wrench to compress the washer.
3. Pull the operator presence control bar toward upper handle.
4. Operate the starter as described above.
Mowing
WARNING:
Always observe the strictest safety procedures when using the lawnmower.
Carefully read the safety instructions of this manual before using the lawnmower.
WARNING:
Never open the ejector flap when the grass bag has been detached (to be
emptied) and the engine is still running. The rotating blade can cause serious injuries!
OPERATION
Fig. 18
Fig. 18-1
