20
model no. 060-0750-0 I contact us: 1-844-428-7277
STORING AND MAINTENANCE
WARNING:
Before performing any maintenance or cleaning work, switch off the engine and
wait until the blade has come to a stop.
Cleaning
General cleaning
The lawnmower should be cleaned thoroughly every time after it has been used. Always clean your
lawnmower immediately after use.
Do not allow grass cuttings and other debris to become dry and hard on any of the mower surfaces.
Dried grass remnants and dirt may impair the mowing operation.
Check that the grass chute is free of any residual grass. Remove any such residue. Check the
underside of the lawnmower and the blade mount. When checking, tilt the lawnmower onto its left
side (opposite the oil filler neck).
NOTE:
Before placing the lawnmower on its side, fully drain the fuel tank using a petrol
extraction pump.
Do not tilt the lawnmower by more than 90 degrees.
Maintenance of the spark plug
As shown in Fig. 19
1. Once the engine has cooled, pull off the
spark cover with a twist.
2. Remove the spark plug using a spark plug
wrench (supplied).
3. Clean the spark plug with a wire brush (not
supplied).
4. Using a feeler gauge, set the gap to 0.7- 0.8
mm.
5. Install the spark plug carefully by hand, to
avoid cross-threading.
6. After the spark plug is seated, tighten with
the spark plug wrench to compress the
washer.
ST
ORING AND MAINTENANCE
Fig. 19
0.7 - 0.8 mm
