11
Setting the Cutting Heights
OPERATION
1
2
There are 2 cutting heights. (Fig 6) shows the
lower cutting height setting, 10 mm. (Fig 7)
shows the higher cutting height setting, 33
mm. The blade is pre-set to the 33 mm cutting
height in the factory.
Height of cut is adjusted by turning over the
cutting head (11) .
Disconnect from the main electricity supply
and wait until the fan (12) and the cutting
head (11) have stopped rotating.
Turn your product upside down.
To remove the cutting head (11) and fan (12)
(Fig. 8), hold the fan (12)
fi
rmly and twist
the cutting head (11) counterclockwise as
illustrated. Hold the cutting head (11) in the
centre and remove as illustrated. Hold the fan
(12) in the centre and remove as illustrated.
Inspect for damage and clean as necessary
before replacing the fan and the cutting head.
IMPORTANT!
Ensure the power cord is disconnected from the mains supply and wait until
the cutting head has stopped rotating before adjusting the cutting height.
WARNING!
A higher cut height (Fig 7) should generally be selected for the first cut of
the season. When cutting longer grass, cut the grass in 2 or more passes,
first on the higher cutting setting then on the lower cutting setting. These
techniques will help to a avoid over-stressing your grass.
11
11
12
12
11
12
11
12
Fig. 6
Fig. 7
Fig. 8