Base unit Manual
2019 Cervis, Inc.
1
1.0
Safety Instructions
Caution!
Carefully
read these instructions to install and use the system properly, to
keep it in safe working condition, and to reduce the risks of misuse.
Do not
use this system in potentially explosive atmospheres.
Any use other than that specified in this manual is
DANGEROUS
.
Strict adherence to the following instructions is a
MUST
.
Note: To comply with United States Federal Communications Commission (FCC) radio
frequency (RF) exposure compliance requirements, this device and its antenna must not be
co-located or operating in conjunction with any other antenna or transmitter.
Caution!
Certain adjustments may need to be made while the controlled
machinery is active. All personnel must be at a safe distance from the
machine during these adjustments to avoid risk of injury or accidental
death.
1.1
What You MUST Do
Strictly adhere
to the installation instructions contained in this manual.
Make sure that professional and competent personnel carry out the installation.
Make sure that all site and prevailing safety regulations are fully followed.
Make sure that this manual is
permanently available
to the operator and maintenance
personnel.
Keep the remote control unit out of reach of
unauthorized personnel
.
At the beginning of each work day, make sure that the
Stop
Button
and other safety
measures are working.
When in doubt, press the
Stop Button
.
Whenever several systems have been installed, make sure the remote control unit you are
about to use is the right one.
Identify
the machine controlled by the remote control unit on
the remote unit label (customer-supplied).
An
audible or visual warning device
indicating that the machine is electrically active and
that the remote control unit has control should be installed on the machine.
Service
the equipment periodically.
When carrying out repairs, only use parts supplied by Cervis, Inc. dealers.
1.2
What You MUST NOT Do
Never
make changes to the system that have not been studied and approved by Cervis,
Inc.
Never
power the equipment with anything other than with the specified power supply.
Never
allow unqualified personnel to operate the equipment.
Never
leave the equipment
ON
after use. Always use the
Stop Button
to avoid accidental
movements.
Never
use the system when visibility is limited.
Never
abuse the remote unit. Avoid dropping.
