Base Unit
2019 Cervis, Inc.
13
Caution
Push-To-Operate (PTO) means that the outputs under control should only change
states when the appropriate handheld button is pressed, and then only for the
duration of time that particular output button is pressed. Investigate any unexpected
motion that occurs when pressing the handheld output control buttons.
Should a jerkiness of motion occur while constantly pressing an output button,
immediately stop operation. Check the OUT LED and the other BU-xH6R diagnostic
LEDs for any indication of a problem.
Be aware that even if the handheld and base unit diagnostic LEDs do not indicate a
problem, one may be present and further troubleshooting steps may be needed.
If a problem is found, do not operate the SmaRT System until the problem is
resolved.
