SmaRT DIN-9H1R5
U082.0.2 DIN-9H1R5
16
C5: DIN-9H1R5/XX-218 Remote Communication
CAUTION
To prevent inadvertent machine movement, be sure to
remove power from the Base Unit before attempting to
Associate or Dissociate.
To Associate (see Figure 10)
Associate mode establishes the communications link between the 18-button handheld remote
and base unit on a 1-to-1 basis.
To Associate:
•
There must be a clear line of sight between the handheld and the base unit
•
The handheld must be near the base unit
—within six feet
•
Both units must be OFF (powered down)
Turn off the 18-button handheld either by pressing its OFF button when the unit is ON, or by
allowing the unit to time-out. Off is indicated when none of the LEDs are active when any
function button is pressed. Safely power down the SmaRT base unit by disconnecting the power
source from the unit.
Figure 10. XX-218 Associate Mode
Note: Observe LED states while performing the following procedure.
1. Remove power from the base unit, and turn off the handheld.
2. Stand near the base unit with the handheld in a clear, unobstructed line-of-sight.
3. Press and hold
button 2
, then press and hold
button 1
. Hold both buttons
simultaneously.
4. Wait until the amber LED2 goes out.
Release the two buttons being held.
5. Press and release
button 16
. The GREEN LED1 and the RED LED3 turn
ON
.
6. Power up the base unit.
If the Association is successful, the AMBER LED2 flashes. If communications are not
established following the Associate procedure, repeat the process until communication between
the handheld and base unit is achieved.
1
