This function requires a door contact.
The “Automatic closure” function increases the battery consumption.
Opening time
Contains the settings for the time period the latch is pulled back.
Prolonged opening times increase battery consumption.
Using the door
status sensor
Here, if there is a door contact, you can define whether that door contact should be used.
Reversing the
door status
sensor
Here you can reverse the signal of the door contact if the door contact signals “door open”
when the door is closed.
Type
Lock type, e.g. motor cylinder or door controller
Power supply
unit
Indicates whether an optional power supply unit is connected or not.
Battery
Indicates the battery voltage measured in the device.
Firmware
Shows the firmware version of the device.
Advanced
Opens the expert menu for the CES service technician.
To ensure that only trained experts can change the settings in the expert menu, it
is protected by a PIN code.
Advanced (expert menu)
Changing the settings in the expert menu could damage both the motor cylinder and the lock
irreversibly! Only change the settings if you know exactly what you are doing!
Settings which have been changed in the expert menu are saved in the motor cylinder. These
changes can affect manufacturer’s warranty!
Reset to
standard
settings
Resets the configuration settings to factory settings.
Rotational
speed
The speed at which the motor drives the cylinder. The rotational speed mainly determines
the force which is used to pull back the latchbolt during the day.
Turning time
to open
The maximum time during which the motor is turning to open the latchbolt. In general,
the motor stops turning in time because the end stop in the lock has been detected.
Turning time
to close
The maximum time during which the motor is turning to close the latchbolt. In general,
the motor stops turning in time because the end stop in the lock has been detected.
Reversing time
Open
Determines how long the motor has to turn to pull back the latchbolt at daytime.
Reversing time
Close
Determines how long the motor has to turn to release the lock after having reached the
end stop in closing direction.
Page 32 of 53
CESeasy motor cylinder
9 Configuration