If the battery warning shows that the batteries are nearly empty, the door controller will continue
to work for some more time. However, the duration of this period depends strongly on the
aspects mentioned in the section
8.4 How to insert and change batteries
Please refer to chapter
on page 48 when changing the batteries.
Tools required:
You can manually remove the design screw of the battery compartment. If the design screw is
too tight, you can loosen it with an Allen key (4mm).
If you want to prevent that the battery compartment can be manually opened, you can
replace the design screw by a safety screw (M4 thread, length 8mm).
Page 24 of 53
CESeasy motor cylinder
8 Batteries
