Fitting
Page 86 of 128
OMEGA ACTIVE IES
22.
Fig. 119 - Mount the crossbar
Shorten the crossbar
(1) as required.
Insert the crossbar
between the two lever
arms (2).
Insert the two lever
arms in the two cover
plates.
Fasten the lever arms
using the M5 × 6 mm
countersunk screws (3)
and seal the four holes
using the cover caps
(4).
23.
Fig. 120 - Fasten the inside shield
Apply the inside
mounting to the base
plate.
Guide the cables (1)
through the upper
opening in the inside
mounting.
Use the two M3 x 6 mm
screws to tighten the
inside mounting.
24.
Fig. 121 - Plug in the plug
connector
Carefully plug in the
plug connector of the
12-conductor cable (1).
Carefully plug in the
plug connector of the
antenna (2).
Make sure that no
contacts are bent in the
process.