Fitting the locking cylinder in a door lock
30
RF-Master-Set
Fitting the cylinder body
The cylinder body is inserted into the profile cylinder hole of
the door lock.
CAUTION
The door may accidentally close while you
are fitting the cylinder and it may not be
possible to open the door again.
Secure the door against accidental closing.
Ensure that a locking medium authorized for
this cylinder is available.
Make sure that the authorizations for the locking
cylinder concerned are granted correctly. Please
refer to the enclosed Programming Instructions
for information on how to authorize a locking
medium.
To check the position of the door fitting and the door lock,
proceed as follows:
Remove the lids of the fitting aid on both sides.
Insert the fitting aid (1) into the profile cylinder hole (2)
until it projects on both the inside and the outside of the
door lock.