Operating the door lock
44
RF-Master-Set
DESFire EV-1 in standard mode
Locking media operating in the standard mode behave like any
other ISO 14443 transponders. For authorization, the UID of
the locking medium is used.
If you manage your systems with the CEStronics software, you
can use both DESFire EV-1 variants with the CEStronics
software.
Move your authorized locking medium (1) into the reading
range of the fitting.
This distance is about 20 mm.
The reader module in the outside knob identifies the locking
medium. The locking cylinder sends a short signal to signal the
enable status.
During the opening time you can open the door. During this
opening time, the locking cylinder does not respond to any
other locking media.
To open the door lock, rotate the outside knob in the
corresponding direction (2).
Release the knob immediately after the door has been
opened. You do not have to turn the knob back into its
original position.
If you are using a locking medium that is not authorized to
enable this locking cylinder, the light ring of the locking
cylinder flashes red four times and you hear four successive
beeps. In this case, the outside knob is not coupled with the
follower. The outside knob rotates freely but the door lock
cannot be operated.