Using the RF Switchpoint
54
RF-Master-Set
Any Mifare locking medium may be authorized as an
"emergency key" with the Program-Master. This
gives you access directly at the locking cylinder.
For a locking cylinder to cooperate with the RF Switchpoint, the
two must be combined to form a group.
To permit grouping, the RF Switchpoint has a learning mode.
In this learning mode, you can combine up to four locking
cylinders into a group for connection with the RF Switchpoint.
You will also need the RF-INI-Master medium to set the locking
cylinder into its learning mode.
Condition: The RF-INI-Master must have been
enabled with the System-Master.
To combine a locking cylinder into a group with the RF
Switchpoint, proceed as follows:
Activate the RF Switchpoint. Establish any required
connections as described in the "Technical Data" chapter on
page 69 ff.
Wait for the start-up phase of the RF Switchpoint to be
completed (about ten seconds). The RF Switchpoint is
operative once the red LED has gone out for a short time
(about 1 second).