Using the RF Switchpoint
RF-Master-Set
55
Set the RF Switchpoint into its learning mode by bridging
the reset bridge RB (1) on the board of the RF Switchpoint
for a short period with a jumper or another object permitting
metallic conduction.
Be sure to avoid short-circuiting or touching any other
points or contacts on the board when bridging the reset
bridge RB (1).
NOTICE
Incorrect bridging may damage the RF
Switchpoint.
Be sure to avoid short-circuiting or touching any
other points or contacts on the board when
bridging the reset bridge RB (1).
In response, the RF Switchpoint signal changes from red to
green. The RF Switchpoint is now in its learning mode. The
green LED will flash regularly for up to three minutes.