Using the RF Switchpoint
56
RF-Master-Set
Enable the locking cylinder with the RF-Master by holding
the RF-Master in front of the locking cylinder.
In response, the cylinder LEDs emit a long (2 seconds) green
signal. The cylinder is now in its learning mode.
A maximum of four cylinders can be enabled.
To end the learning mode, activate the reset bridge.
This is acknowledged by four short consecutive flashes of the
green LED of the RF Switchpoint.
If no cylinder is enabled, the red LED emits four
short consecutive flashes and the previous grouping
will be reset.
If the enabling process fails, repeat it.
This completes the grouping.