Using the RF Switchpoint
58
RF-Master-Set
To use the remote authorization, proceed as follows:
Activate the RF Switchpoint. Establish any required
connections as described in the "Technical Data" chapter on
page 69 ff.
Connect the device with which you want to trigger the
authorizations (push-button, higher-order control, etc.) with
the enable input.
Trigger the authorization.
Rotate the outside knob of the locking cylinder by a couple
of notches.
Release the knob immediately after the door has been
opened. You do not have to turn the knob back into its
original position.
If the authorization has been set correctly, the locking cylinder
should now signal free entry with its green LEDs.
Open the door.