Introduction
22
OMEGA Mifare wall terminals
WT-M-II
Only use J-Y(St)-Y 2
2
0.6 mm² cables for the
connection between the control unit and the
reader module.
After the cable has been laid, the connection must
be established, see page 26 ff.
1
Reader terminal (outside terminal) for wall terminal type
WT-M-II (housing: CES Standard)
2
Fitting frame
3
Controller terminal type WT-M-II (inside terminal) with
cable for permanent connection with the reader terminal
(not connected to reader terminal when supplied,
housing: CES Standard)
4
Fitting frame
5
4 universal screws 2.5
20 mm
6
4 fastening screws 3
30 mm with 4 plugs
