Fitting the wall terminals
OMEGA Mifare wall terminals
33
Disassembly of the wall terminals
The wall terminal is supplied preassembled. Before fitting, the
wall terminal must first be disassembled.
Disassembly is similar for all versions of the wall terminal. The
following describes the disassembly for the wall terminal in the
CES standard housing.
For the WT-M-II wall terminal, you must perform the following
steps also for the reader module.
Disassembly may vary depending on the ordered housing
version.
The following tool is required:
Screwdriver with suitable tips / bits for slotted-head screws
and recessed head (Phillips) screws
To disassemble the WT-M-I wall terminal, proceed as follows:
Lift the wall terminal from the fitting frame.
You now hold the control module with the cover in your hands.
Release the cover carefully from the control module using a
wide slotted-head screwdriver.
