Fitting the wall terminals
OMEGA Mifare wall terminals
37
Fitting the WT-M-I wall terminal
The wall terminal is supplied preassembled. Before fitting, the
wall terminal must first be disassembled.
Follow the steps for disassembling the WT-M-I wall terminal
on pages 33 ff.
For fitting the wall terminal without the fitting frame, you need
already installed and prepared in-wall switch boxes. All
required cable connections must already be available in the
switch box. The supplied fitting frame is not required in this
case.
If you are using fitting frames, please follow the fastening
instructions on page 35 ff.
Ensure that the in-wall switch box has been installed
horizontally.
The mounting holes of the wall terminal must always
be aligned horizontally, also when the wall terminal is
installed on in-wall switch boxes.
Ensure that all required cables have been guided through
the switch box without being damaged or squeezed.
Establish all required wire connections as described in the
"Connections" chapter on page 23 ff.
