CET Electric Technology
50
are supported via the Web Interface and Modbus communications. The SNTP server provides the
following setup parameters:
Setup Parameters
Definition
Default
Set Clock
Disable/Enable SNTP
Disabled
Time Zone
See Section 5.11.1 Basic Setup Parameters, Register 6053
26 (GMT+08:00)
Interval
SNTP Time Sync. Interval from 1 to 1440 minutes
60
Server IP
The IP Address of the SNTP Server
192.168.0.94
Table 4-17 SNTP Setup Parameters
4.7.2 SMTP
The PMC-53A-E can be configured to send Alarm Emails based on the Simple Mail Transfer Protocol
(SMTP).
Setup Parameters
Definition
Options/Default*
Server IP
The IP Address of the SMTP Server
See Note 1)
Port
The IP Port No. for the SMTP Server
0 to 65535, 25*
Sender
Sender’s email address
5
See Note 2)
Password
SMTP Server’s logon password for Sender’s email address
See Note 3)
Receiver
Receiver’s email address
5
See Note 4)
Table 4-18 SMTP Setup Parameters
Notes:
1)
The SMTP Server’s IP Address, for example, 192.40.165.68, should be programmed into the Server IP setup parameter.
2)
The default Sender’s email address is
3)
The Password should not exceed 20 ASCII Characters.
4)
The default Receiver’s email address is
. Only one Receiver email address is supported.
5)
Both the Sender and Receiver setup parameters should not exceed 36 ASCII characters.
Here is an example on how to configure a Setpoint to trigger an Alarm Email:
1.
Click on Setup -> Comm. and configure the SMTP settings as shown below. Please note that all the
SMTP setup parameters should be entered correctly.
Figure 4-4 Setup SMTP via Web Browser
2.
Click Save to store the configuration in the PMC-53A-E. The message “
Successful” will appear if
the configuration is accepted by the meter. Then click Send as illustrated in the above figure. The
message “
Successful” will appear if a test email has been successfully sent to the Receiver, who
should receive the following Test Email. However, if the “
Successful” message is not displayed,
it means that the test email has not been sent successfully because of incorrect configuration.
