71
15. INSTALLING YOUR CHARTNAV
3 4 3
15.1 Before You Start
Before commencing the installation of your new Chartnav 343
system please carry out the following checks:
that the correct items have been delivered
that the units are undamaged
that you have a power cable of a suitable gauge to supply
power to the system
that you have a Circuit Breaker of a suitable size for the
system
that the cables supplied with the unit are of sufficient
length and that you have suitable terminal blocks and
cables to complete your installation.
If you find an error please contact the supplier of the product
immediately.
Before drilling or cutting any holes, please consider the exact
location and cable routing that is required for each unit. Please
read this Installation section and the installation information
supplied with any associated equipment, before you install the
Chartnav 343 system.
15.2 Suggested Procedure
We suggest that the following procedure will allow you to
install the system encountering the least problems.
Read this manual, then select the best position for the unit.
Mount and install the unit as directed.
Then proceed to connect the cables to the unit as shown
in the section 15.12 Installation Schematic.
Finally
Connect the supplied fused with a 1 Amp in-line fuse.
In the Installation Settings Menu, select the correct
interface with other units connected to your system.
All manuals and user guides at all-guides.com
all-guides.com
