CHARTNAV 343
74
Figure 40 - Template (not to scale)
15.8 Connecting Your Position-Finding Instrument
To enable the Chartnav 343 to plot the vessels position and
track its course the Chartnav Control Unit must be connected
to a position-finding instrument.
Connect your position-finding device as shown in the
Installation Schematic. NMEA Navigators, for example the
930 940 GPS Antenna, should be wired to the 6 Way female
cable connected to External GPS Port on the Chartnav Control
Unit.
If your instrument is able to output combined Instrument and
navigator data, it should be connected via the 7 Way Female
cable to Power I/O Port.
The Chartnav 343 should have only one source of navigation
data, connected either to External GPS Port or Power I/O Port
as detailed above.
If navigator data is being sent via Port 2, C-net data such as
depth or speed (with no GPS information) may be connected
through Port 1.
15.9 Connecting An Autopilot
An Autopilot should be connected to the Chartnav 343 using
the Brown and Grey wires of the 7 way cable, (as shown in
the Installation Schematic diagram in section 15.12).
15.7 Template
All manuals and user guides at all-guides.com
