Chapter XI Protocol Analyzer (Option)
125
screen:
Fig. 11.148 FlexRay Identifier Trigger When Menu
Rotate the Multipurpose b to select the corresponding Trigger When, and then press it down to confirm Select, or
directly click the corresponding Trigger When setting on the screen.
Click [Identifier] menu key, and the Identifier setting numeric keypad will pop up on the left side of the menu:
Fig. 11.149 Numeric Keypad
Set the Identifier through keys on the numeric keypad or Multipurpose a and Multipurpose b.
Click [Identifier Low] or [Identifier High] menu key, and the numeric keypad same as the [Identifier] menu key
setting as shown in the above figure will pop up on the left side of the menu, and the setting method is the same.
Click [Cycle Count] menu key and set the FlexRay trigger type to Cycle Count, and the menu at the bottom of the
screen will be switched to the Cycle Count Trigger Type setup menu:
Fig. 11.150 FlexRay Cycle Count Trigger Level1 Menu
Click [Cycle Count] menu key, and the Cycle Count setup menu will pop up on the right side of the screen:
Fig. 11.151 FlexRay Cycle Count Trigger Level2 Menu
Summary of Contents for 4456 Series
