CFMOTO
05-26
1 Cylinder #1
2 Cylinder #2
General rules should be followed below:
In cylinder head/cylinder body exploded
view, same part uses the same numbers;
different parts or only one part, use
different part numbers.
The service difference between cylinder 1
and cylinder 2 has special instructions in
this manual.
When the engine shows trouble, the
cylinders should be diagnosed separately.
The vehicle must be stopped on a flat
ground.
Note: For better understanding, most of
the drawings show the engine in a removed
state. If there is no need to remove the
engine, make sure the work below is done:
1.Disconnect the negative cable of the
battery before working on engine. Then
disconnect the positive cable.
2.Many parts may not need to be removed
when working on only one part. CFMOTO
recommends to remove only that part for
inspection if possible.
3.During assembly, follow the exploded
views for the torque and service materials.
4.Clean the screw threads before covering
with thread locker.
Warning: Use torque wrench to tighten
up screws. Locking parts (Locking washer,
Locking nut, Cotter pin) must be replaced.
If removing many same parts (i.e. Valves).
Please mark the position (i.e. PTO/MAG,
#1 cylinder/#2 cylinder), and separate
them. If parts are damaged, it will be easier
to find out the reason from related parts.
5.2.2 General
052601
1
2
Summary of Contents for CF1000ATR 2018
