CFMOTO
05-40
1
Washer
(Spark plug
side)
2
Washer
(Timing
chain
side)
3
Rocker
arm
shaft
1 Diameter measuring position
054001
054002
Rocker arm shaft inspection
Inspect rocker arm shafts for scratches.
Replace shafts as necessary.
Measure rocker arm shaft diameter.
Rocker arm diameter
New
11.973mm~11.984mm
(0.4714in~0.4718in)
Service
limit
11.960mm
(0.4709in)
If reached the service limit, parts must be
replaced.
Install the rocker arms
Note: Use the same way to install the
intake and exhaust rocker arm.
Pre-lubricate the rocker arm shaft. Insert
the bevel side first. Then follow the steps
below to complete the installation:
Insert the rocker arm shaft to the hole on
the rocker arm.
Install the washer and make sure the arm
is right (Intake or Exhaust).
Then push the shaft until it reaches the
end.
Install another washer then push the shaft
to the end.
Timing chain
See timing chain in CRANKCASE chapter.
1
1
2
3
Summary of Contents for CF1000ATR 2018
