5.2 Intake Pipe, Cylinder Head and Cylinder Body
05-41
1 Cylinder head bolt M10 2 Bolt M6
1 Cylinder head 3 Chain guide
2 Timing chain 4 Cylinder head gasket
054101
5.2.9 Cylinder head
Remove the cylinder head
The 2 cylinder heads remove in the same
manner.
Drain out the coolant (See cooling system).
Note: Use compressed air to blow
out the coolant left before removing the
cylinder head. If the coolant flows into the
engine, it will cause engine oil dilution.
Remove the both side panels and inner
fenders.(See body covering parts).
Disconnect the ignition.
Disconnect the temp sensor connector on
the cylinder head.
Disconnect the radiator inner hose.
Remove the chain tensioner.
Remove exhaust pipe spring and clamp.
Remove exhaust nuts.
Remove the air filter housing.
Remove the throttle valve.
Remove the intake manifold.
Remove the cylinder head cover and
gasket. (See cylinder head cover)
Remove camshaft timing sprocket.
Follow the special order to remove the
cylinder head mounting bolt M6 and M10.
Pull out the cylinder head.
Remove the timing chain guide.
Remove the gasket (4) and discard it.
054102
4
3
2
1
2
1
Summary of Contents for CF1000ATR 2018
