5.3 Crankcase, Crankshaft and Gears
05-101
1 Washer
17.5×32×1 5
Shifting
Slide
Sleeve
9
Driven
Output
Shaft
2 Driven Low
Gear
6 Retainer
29
10
Driven
Reverse
Gear
3 Needle
Bearing
7
Driven
High
Gear
11 Retainer
29
4 Washer
24.5×33.5×1 8
Driven
Shaft
12 Parking
Gear
0510101
0510102
1 Groove Width
Gearshift Driven Shaft Assy
Disassemble gearshift driven shaft assy as
shown.
Check teeth of each gear for fittings,
scuffing and excessive wear. Check needle
bearing and circlip for wear and damages.
Replace if necessary.
Gear
Note: Gears must be replaced in pair.
Always replace circlip after removal.
-driven shaft output gear for reverse gear
shifting
-gearshift sliding sleeve for high and
low gear shifting. Measure the width for
engegement of shift fork. If the width is out
of specification, replace the gear.
The width for engegement of shift fork on
the gear should be the same with the one
on the sliding sleeve.
Shifting groove width
New
6.1mm~6.2mm
(0.240in~0.244in)
Service limit
6.3mm(0.248in)
12
6
11
7
5
4
3
1
2
10
6
1
8
9
3
6
3
6
Summary of Contents for CF1000ATR 2018
