CFMOTO
05-102
0510203
A .Gear Inner Diameter
0510202
0510201
1 Reverse Intermediate
Gear Inner Diameter A
Gear Inner
Diameter
Inspect reverse driven gear, high range
gear, low range gear for damages.
Measure the gear inner diameter, if it’s out
of specification, replace the gear.
The inner diameter of reverse driven gear,
high range gear, low range gear are the
same.
Gear inner diameter
New
29mm~29.021mm
(1.1417in~1.1426in)
Service limit
29.025mm(1.1427in)
Driven Shaft
Check driven shaft for damages.
Check driven shaft for pittings, scouring
and excessive wear. Replace if necessary.
Measure driven shaft neck diameter, if it’s
out of specification, replace it.
Driven s haft
Service limit
A
16.978mm(0.6684in)
B
23.974mm(0.9439in)
Reverse Intermediate Gear
Check reverse intermediate gear for
damages. Measure the inner diameter. If
it’s out of specifiacation, replace it.
Reverse inter gear inner diameter
New
29.007mm~29.028mm
(1.1420in~1.1428in)
Service limit
29.032mm(1.1430in)
A
A
B
B
B A
A
1
Summary of Contents for CF1000ATR 2018
