CFMOTO
05-132
5.5.2 General
Lubrication is employed to reduce the
wear of some components, such as
piston, crankshaft, camshaft, etc, which
moves relative against other parts. Proper
lubrication is the basis for engine normal
operation.
The engine crankcase and gear box use
different oil for lubrication. Lubricating oil
has cleaning, anti-rust, sealing, cooling
and other functions besides lubrication.
Warning
Torque wrench must be used when
tightening. Locking devices(e.g.: locking
tabs, elastic stop nuts,cotter pin, etc.) must
be replaced with new ones.
5.5.3 Engine Oil Level Check
Ensure vehicle is on a level surface;
Start the engine and allow it to idle for a
few minutes, then shut it off. Wait for a few
minutes to allow oil flow down to crankcase
then check oil level;
Unscrew dipstick and wipe the oil residue
off, then put dipstick in the hole. Don’t
screw in dipstick to read oil level, just make
dipstick threads contact the hole surface;
Remove dipstick and read oil level;
Engine oil level must be between “upper”
and “lower” marks;
If oil level is below “lower”, refill the oil and
check the level again and again until it is
OK.
Install the oil dipstick back.
Note:
Strictly follow the procedure above,
otherwise wrong oil level may be indicated;
Vehicle must be placed on a level surface;
Don’t screw in dipstick to read oil level.
Oil dipstick line:
1 Upper
2 Lower
0513201
1
2
Summary of Contents for CF1000ATR 2018
