CFMOTO
05-168
0516801
1 Leak Indicator
Hose
Check all hoses, radiator and cylinder(s)/
base for coolant leaks or air bubbles.
Inspection
Check general condition of hoses and
clamps tightness.
Check the leak indicator hose for oil or
coolant.
Note: A small amount of coolant from
the water seal in the hose is considered
normal. A leak inidcator hose continously
dripping is leaking. The water seal must
be replaced. Leaking coolant indicates a
defective rotary seal. Leaking oil indicates
a defective inner oil seal. If either seal is
leaking, both seals must be replaced at
the same time. Refer to Water Pump Shaft
and Seals in this section.
5.8.4 Maintenance
Coolant Replacement
Warning
To avoid potential injuries, don’t remove
the radiator cap or loosen the cooling drain
plug if the engine is hot.
Use premixed coolant or a blend of 50%
antifreeze with 50% water.
To avoid antifreeze deterioration, always
use the same brand. Never mix different
brands unless cooling system is completely
flushed and refilled.
Warning: To prevent rust formation or
freezing condition, always fill the system
with premixed coolant or with 50%
antifreeze and 50% water. Don’t use tap
water, 100% antifreeze or 100% water in
the system.Tap water contains minerals
and impurities which build up in the
system. During cold weather, 100% water
causes the system to freeze while 100%
antifreeze thickens and does not have
the same efficiency. Always use ethylene
glycol antifreeze containing corrosion
inhibitors specifically recommended for
aluminum engines.
1
Summary of Contents for CF1000ATR 2018
