CFMOTO
05-194
●Load 12V between auxiliary starter
relay positive and negative terminal. Use
multimeter to check the continuity between
A and B.
(Turn multimeter to DIODE)
●If multimeter clicks,it indicates there is
continuity between A and B.
●If 12V is removed, no continuity remains
between contacts.
●If both the above two items are in good
condition, it indicates the replay is well.
●Turn multimeter to 1×100Ω, measure
auxiliary starter relay resistance.
Auxiliary starter relay resistance:
70Ω~90Ω
5.9.2.7 Auxiliary Starter Relay and Fuel
Pump Relay
0519401
5.9.2.8 Engine Starting Notice
●Properly route according to starting
schematic diagram.
●Before starting, check if all parts are
fitted correct. Regarding EFI components
connection, refer to EFI section.
●Check air intake system.
●Check fuel supply system. Ensure there
is no block or leaks.
●Test fuel pressure with fuel pressure
gauge.
Pressure in fuel pump outlet:
0.33MPa±0.01MPa
●Place the transmission in Neutral.
●Check EFI with PDA for fault. If there
is, eliminate the trouble according to
DTC(Diagnostic Trouble Code).
●Turn on the engine ignition switch, then
press starter switch for about 3~5 seconds.
●After starting, warm up until idle speed is
stable and check it.
Idle Speed:1300r/min±130r/min
0519402
Note: If the idle speed is not stable or
too high, turn the ignition off for a few
seconds. Then start the engine again.
A
B
Summary of Contents for CF1000ATR 2018
