CFMOTO
05-228
Item
Procedures
Results
Next
1
Connect fuel pressure gauge, and turn on ignition
switch or start engine. Check if fuel pressure is
approximately 300kPa.
YES Next step
NO
Repair fuel supply
system
2
Disconnect high-tension cable, connect spark tester
and set its electrode to 5mm, then start engine to
check if blue and white spark appears
YES Next step
NO
Repair ignition
System
3
Disconnect water temp.sensor connector and start
engine to check if engine can start.(or use one
2500ohm resistance to replace water temp.sensor)
YES Repair circuit or
replace sensor
NO
Next step
4 Slightly draw throttle cable and check if engine can
start easily
YES Clean throttle body
and by-pass
NO
Next step
5 Disassemble injector and use special tool to check
if there is leakage or block
YES Replace
injector
NO
Next step
6
Check whether the failure happens right after filling
fuel
YES Change fuel
NO
Next step
7
Check if cylinder pressure is sufficient
YES Eliminate engine
mechanic failures
NO
Next step
8
Connect PDA and switch on ignition to check ECU-
G1,F1,P4, and O4 pin if it is powered normally;
Check ECU-Q2,H3 and C3 pin if it is connected to
ground normally.
YES Check with PDA
NO
Check circuit
Item
Procedures
Results
Next
1
Check if air filter is blocked or air intake pipeleaks
YES Repair air intake
system
NO
Next step
(5) Difficult to start in any conditions.
General failure part 1.Water in fuel tank 2.Fuel pump 3.Water temp. sensor 4.Injector
5.Ignition coil 6.Throttle body and by-pass 7.Air intake pipe 8.Ignition timing 9.Spark plug
10.Mechanical part of engine.General diagnostic procedures:
Summary of Contents for CF1000ATR 2018
