CFMOTO
06-38
Trouble
Probable Cause
1,The vehicle running unstable during
acceleration and deceleration.
2.CV shaft and drive shaft noise.
3,CV shaft leaking grease
4,Engine power cannot transmit to front or
rear wheel.
A. CV shaft pulled out from axle.
B. CV shaft rod broken or ball joint
damaged.
C. CV shaft, drive shaft boot cracks.
D. Front drive shaft joint damaged.
E. Rear drive shaft broken or splines
damaged.
F. Locking bolts loose.
6.7 Drive shaft
6.7.1 Maintenance information of CV shaft and driveshafts
Inspection and repair
If the troubles below come out, it means the CV shaft or drive shafts are damaged.
NOTE: Probable Causes requires careful analysis. Isolate the trouble to make sure
the engine and gear cases are not the cause. Remove the part if necessary.
Inspect and analyze:
1.Pay attention for any strange noise.
a. If the vehicle accelerates and decelerates with noise, the noise may not be related
to engine and gear cases.
b. Possible CV shaft joint damage.
c. Possible vehicle bearing damage.
2.Inspect the CV shaft boots and drive shaft boots. Replace if damaged.
3.If a CV shaft will not install, inspect for damage to the splines. A failure will cause the
power transmission to cut.
Warning: If vehicle has trouble during use, stop the vehicle to check and diagnose the
trouble. Operating it may cause an accident.
Summary of Contents for CF1000ATR 2018
