CFMOTO
06-44
6.7.6 Rear drive shaft disassemble and inspection
●The two joints of the drive shaft should move freely. If jammed, not smoothly running or
noise in normal angle, replace the parts.
●Inspect the dust boots (2 and 6) on drive shaft. Replace the parts if damaged.
●Check that the inside of the boots have sufficient grease, or the splines may be
damaged or worn.
●Inspect the splines on both ends. Replace the parts if worn or damaged.
●Inspect the inner and outer spline rotating clearance. If the clearance is more than 1.5
degrees, replace the parts.
NOTE:
Inject 15g~18g grease into both ends during assembly.
064401
Summary of Contents for CF1000ATR 2018
