01 Maintenance Information
01-1
1 Maintenance Information
1.1 Precautions . .................................................................. ..... ...............1-1
1.2 Location of VIN/EIN..................................... ...................... .................1-3
1.3 Main Specification ....................................................... ............ ...........1-4
1.4 Specification .......................................................................... ............1-6
1.5 Tighten Torque ...................................................................... .............1-8
1.6 Lubricant and Sealant .... ....................................................................1-10
1.7 Cable,Cooling System and Brake System .........................................1-11
1.7.1 Wiring Diagram...............................................................................1-11
1.7.2 Brake System Diagram ..................................................................1-14
1.7.2.1 Brake System (Left-hand park) ...............................................1-14
1.7.2.2 Brake System (EU 167 Left-hand park) ..................................1-15
1.7.2.3 Brake System (Right-hand park) ............................................1-16
1.7.3 Cooling System Diagram .................................... ...........................1-17
1.1 Precautions
Safety Cautions
1. Wear suitable work clothes, cap, boots. Wear glasses, dust-proof mask, and gloves if
necessary.
2. Exhausted gas is posionous. Do not run the engine in a closed or bad ventilated area
for a long time.
3. Engine and muffler temperatures are still high when the engine is just stopped. Avoid
getting burned. Do not touch the engine before it has completely cooled down.
4. Battery electrolyte (dilute sulfuric acid) is highly caustic and can result in burns. If you
spill electrolyte on skin, flush with water and seek for medical attention immediately. If you
spill electrolyte on clothes, flush with water to avoid burns. Keep battery and electrolyte out
of reach of children.
5. Coolant is poisonous. Do not drink or spill it on skin, eyes or clothes. If you spill coolant
on skin, wash with soap and water. If you spill coolant on eyes, flush with water and seek
prompt mediacal attention. If coolant is swallowed, induce vomiting and ask a doctor for
medical care. Keep coolant out of reach of children and away from pets.
6. Gasoline is highly flammable. Keep gasoline away from sparks. Vaporized gasoline is
also explosive. Fuel and operate vehicle in a well-ventilated area.
7. Be careful not to get pinched by the turning parts, like wheels, axles, and clutch.
8. When more than two persons are working on the vehicle, remind each other of
operational safety.
Cautions for Removal and Installation
1. Use genuine CFMOTO parts, lubricants and service products.
2. Store the removed components separately in order for correct installation.
3. Clean mud, dust before servicing.
4. Replace removed washers, O-rings, piston pin retainers, cotter pins with new ones.
5. Elastic retainers might get distorted after disassembly. Do not use loosened retainers.
6. Clean and blow off the detergent after removal. Apply lubricants on the surface of
moving parts.
7. If you do not know the length of screws, install the screws one by one and make sure
they are screwed with the same depth.
8. Pre-tighten the bolts, nuts and screws, then torque them to specified specification.The
basic sequence is: from big to small, from inside to outside and criss-cross.
Summary of Contents for CF1000ATR 2018
