03 Periodic Inspection and Adjustment
03-7
Rear Brake Fluid Level
Inspect brake fluid level.
When brake fluid level is below the
"LOWER" mark, inspect master cylinder,
brake lines and connections for leaks.
Unscrew reservoir cap (1) to remove it.
Add DOT 4 brake fluid only. Never exceed
the mark "UPPER".
NOTE
· Do not add fluid to a low reservoir without
checking for brake pad wear first.
· Do not allow dust or water into the brake
fluid.
·Use only DOT 3 or DOT 4 brake fluid to
avoid chemical reaction.
·Don’t spill brake fluid on plastic or rubber
parts, as it could damage them.
Brake Fluid Replacement
Replace brake fluid every year.
Rear Brake Disc & Rear Brake Pads
Brake Pad Wear
Inspect rear brake pads from the marked
place.
Replace rear brake pads if they are worn to
service limit groove.
Braking Pad service limit: 1.5mm
CAUTION:
Pads should be replaced as an assembly.
Brake Disc Inspection & Replacement
Inspect brake disc (2) for excessive wear
or damage. Replace brake disc when its
thickness is less than 4 mm.
Braking Disc service limit: 4.0mm
Brake Fluid Replacement
Replace brake fluid every year.
030702
Rear brake disc
LOWER LINE
030701
1
2
Summary of Contents for CF1000ATR 2018
