01 Maintenance Information
01-3
Engine Break-in
There are many movable components inside the engine, such as the piston, piston rings,
cylinder, crankshaft, gears, ect. During initial use period, proper run-in for every critical
component is necessary. Break-in can help engine components match to each other and
adjust to working conditions. Careful treatment of a new engine will result in more efficient
performance and a longer service life.
Recommended break-in period: First 600km
Operation guide:
0~300km: Do not operate continously at more than 50% throttle position. Cool down the
engine for 5~10 minutes after every one hour of operation. Avoid sudden acceleration.Vary
the throttle position slowly and smoothly.
300km~600km: Avoid long-time running at more than 75% throttle position. Do not open
throttle completely during this period.
NOTE:
1.Maintain and repair with regular procedures during break-in period.
2.After break-in, check and maintain the engine before normal use.
1.2 Location of VIN/EIN
Model:CF1000AU;CF1000ATR
1.Vehicle identification number(VIN): LCELV1Z5; LCELVYZ8~
2.Name plate (Vehicle identification number label)
3.Engine identification number(EIN): 2V91Y
010301
010302
3
2
1
Summary of Contents for CF1000ATR 2018
