CFMOTO
05-4
5.1.1 Precautions
WARNING: Working on the engine in the right way is important for technicians safety
and engine reliability.
·Make sure the exhaust gas can be vented out if starting the engine indoor.
·Use extreme caution when working with poisonous or high-flammable material. And
make sure the working place is well ventilated.
·Do not use gasoline as washing liquid.
·To avoid heat burns, do not touch the uncooled engine oil, radiator and exhaust system.
·If fuel, lubrication, cooling and exhaust system has been maintained. Inspect for leaking
and level.
·To protect the environment, dispose of wasted oil or coolant properly.
WARNING :
·Use CFMOTO authorized parts or recommended products.
·If the removed parts need to be reused, please put them in order to avoid mixing up.
·Make sure the part for assembly is clean. Pre-lubricate it if needed.
·Use special oil, glue and sealant for engine assembly.
·When tightening bolts, screws or nuts, tighten larger ones first, and then tighten up from
inside to outside.
·Use a torque wrench to tighten bolts to special torque. If the screws have grease or oil,
it must be cleaned up.
·When a part is removed, it should be inspected and cleaned up before measuring.
·Inspect the part tightening and running after installation.
·Do not use used oil-seals, O-rings, gaskets, self-lock nuts, locking gasket, cottor pins
and retainers. Replace with new ones.
Summary of Contents for CF1000ATR 2018
