GB15
GB16
CFI EXTEL EWATCH 900 07/2017
CFI EXTEL EWATCH 900 07/2017
13. MAINTENANCE - WARRANTY
The warranty is void if parts have been dismantled. Clean the outside with a soft, dry cloth only. Before cleaning,
disconnect or switch off the video surveillance system.
NOTE
Do not use any gasoline or carboxylic acid, alcohol or similar treatment. In addition to damaging your device, the
fumes are also hazardous to your health and are explosive.
Do not use any tool that can conduct voltage (wire brush, sharp tool, etc.) for cleaning.
If required, our technical site is at your disposal: www.cfi-extel.com
The latest version of the instructions in colour is downloadable from:
www.cfi-extel.com
WARRANTY CONDITIONS:
This product is guaranteed for parts and labour in our workshops.
The warranty does not cover: consumables (batteries, etc.) and damage caused by misuse, improper use, improper
installation, external intervention, damage due to physical or electrical shocks, dropping, or atmospheric phenom-
ena.
• Do not open the device, as this will void the warranty.
• If the unit is returned for After Sales Service, protect the unit to prevent scratches.
• Clean with a soft cloth only, no solvents. The warranty is void if parts have been dismantled. Clean the outside
with a soft dry cloth only. Before cleaning, disconnect the equipment or switch it off at the mains.
The receipt or invoice is proof of purchase date.
14. SAFETY MEASURES
Any damage caused by failure to adhere to the manual shall void the warranty. We shall not be held liable for any
resulting damage!
We shall not be held liable for any damage to property or persons caused by incorrect use or failure to comply
with safety instructions.
This product has been manufactured in full compliance with safety instructions. In order to maintain this status
and get the most out of the product, users must adhere to the safety instructions and warnings contained in this
manual.
15. FCC/CE WARNING
Note: This equipment has been tested and found to comply with the limits for the Class B, in compliance with
current European safety standards. These limits are designed to provide reasonable protection against interfer-
ence in a residential installation. This equipment uses and emits a radio frequency energy and if not installed and
used according to the instructions it may cause interference with radio communications.
However, there is no guarantee that there will be zero interference in any given installation. If this equipment
causes interference with radio or TV reception, which can be determined by starting and stopping the equipment,
we recommend resolving this interference by using at least one of the following measures:
• Reorient or move the receiving antenna
• Increase the distance between the equipment and the receiver
• Use a plug on a different circuit to that being used by the receiver
