CFI EXTEL VisioSmart - 04/2017
GB3
FACTORY DEFAULT SETTING
Press and hold the reset button on the power cable for 5 seconds and the system will start the
reset process. The system will restore to factory default and you may start the Wi-Fi setup.
SAFETY INSTRUCTIONS
Damage caused by the failure to follow the instructions in this manual lead to the termination of the warranty. We cannot be
held liable for the resulting damage!
We cannot be held liable for any damage to property or injury to persons cause by incorrect handling or the failure to follow
the safety instructions.
This product has been manufactured in full compliance with safety instructions. In order to maintain this state of affairs and
ensure the best use of the product, the user must follow the safety instructions and warnings contained in this manual.
The person using this system is responsible for it and must check that the video surveillance compiles with the laws applicable
in the country of use.
- You must only use this product at a voltage included between: 100-240 Volts and 50-60 Hertz. Never attempt to use the
product with another voltage.
- Make sure that all the system’s electric connections are compliance with the usage instructions.
- In commercial establishments, make sure you follow accident prevention rules for electric installations.
- In schools, training infrastructures, workshops... the presence of qualified staff is required to check the operation of electronic
devices.
- Please contact an experienced person if you have doubts as to the operation or safety of the appliances.
- Never connect or disconnect electric appliances with wet hands.
- When installing this product, check that the power supply cables are not in danger of being damaged.
WARNING
Warns the user of the presence of important instructions about
use and maintenance (repairs) in the documentation delivered
with the appliance.
FCC/CE WARNING
Comment: This equipment has been tested and found compliant with the limits of a class B appliance, in compliance with
applicable European standards. These limits are designed to provide reasonable protection from interferences in a residential
installation. This equipment uses, and can transmit radio frequency energy and, if not installed and used following instructions, can
cause interference to radio communications.
However, there is no guarantee that the interferences will not occur in a specific installation. If this equipment causes
interferences to radio or TV reception, which can be determined by powering the equipment on and off, the user is encouraged
to attempt to rectify the interferences using at least one of the following methods:
• Redirect or move the receiver antenna
• Increase the distance between the equipment and the receiver
• Connect the equipment to a socket on a different circuit than the circuit the receiver is connected to
Summary of Contents for 720303
Page 2: ......
