Install of The Compact Panel Cassette Type Indoor Unit
8
2.9 Install the panel
(1).
Set the panel to the indoor unit body by matching the position of the swing flap motor of the
panel to the piping position of the panel to the piping position of the indoor unit as shown by fig.13.
(2). Install the panel
① .
Install the panel on the indoor unit temporarily. When install, hang the latch on the hook
that is located on the opposite side of the swing flap on the panel of the indoor unit. (2
positions)
② .
Hang the remaining 2 latches to the hooks on the sides of the indoor unit.(Be careful not to
let the swing motor lead wire get caught in the sealing material.)
③ .
Screw the 4 hexagon head screws under the latches in about
0.59in (
15mm
)
. The panel
would rise
.
④ .
Adjust the panel by turning it toward the direction pointed by the arrow as shown in fig.13,
so that the adjust board connect the ceiling well.
⑤ .
Tighten the screws until the thickness of the sealing material between panel and indoor
unit reduced to
0.2-0.3in (
5-8mm
)
.
Fig.13
Notes:
① .
Improper screwing of the screws may cause the troubles shown in fig.14.
