How to replace the motors (Located underneath
the chair)
1. Unzip the zipper on the edge of the seat. (Reference picture 1 and 2)
2. Tear off the Velcro that attached on the seat. (Reference picture 3)
3. Loosen the six chrome screws on the underneath of the seat. (Reference picture 4)
4. Loosen the three flower screws locates on the inner side of armrest (Reference
picture 5 and 6)
5. Disconnect two air hoses from chair. Then remove the right armrest. (Reference
picture 7)
6. Loosen the four screws on the leg of chair. Then you can see the motors and plugs.
(Reference picture 8, 9 and 10)
7. Locate the motor which needs to be replaced (red plug = back recline ; yellow plug
= footrest ; white plug = Inversion recline ; blue plug = foot lengthen)
8. Disconnect the color coded plugs.
9. Loosen the nuts and bolts, and slide out the bolts.
10.You may need to cut any zip ties to completely remove the motor from the frame.
Please be careful to only cut the zip ties, do not cut any wires.
11. Get replacement motor and align it where the old motor was.
12.Slide in the bolts on each end of the motor and fasten the bolts.
13.Connect the color coded plugs.
14.Test and see if the new replaced motor can go up and down.
15.Plug in wire and install the chair as step 7 to 1.
- 16 -
Summary of Contents for TS-8800
