Helpline No 0844 801 8701 / IRE 189 094 6244
12
7.2
Adjusting the splitter (Fig. 4-6)
• Remove the saw blade guard (2) (see 7.3).
• Take out the table insert (6) (see 7.4).
• Slacken the two hexagon socket-head screws
(24).
• Adjust the splitter (5) so that the gap between the
saw blade (4) and the splitter (5) equals 3 - 5 mm
(see Fig. 6)
• The splitter (5) has to be in line with the saw blade
(4) in longitudinal direction.
• Retighten the two screws (24).
• The setting of the splitter has to be checked each
time after changing the saw blade.
7.3
Fitting the saw blade guard (Fig. 4)
• Mount the saw blade guard (2) on the splitter (5)
and align.
• Insert the screw (15) through the hole in the saw
blade guard (2) and in the splitter (5) and secure it
with the nut.
• To remove the saw blade guard, proceed in
reverse order.
7.4
Replacing the table insert (Fig. 4)
• Caution! Pull out the power plug.
• Remove the 6 screws (23).
• Take off the saw blade guard (2) (see 7.3).
• Lift the worn table insert (6) up and out.
• Fit a new table insert in reverse order.
