APR 2018
CMT-330TC Three-Knife Trimmer
2-11
2. Installation Guide
2.4.5 Long Hand-Feed Conveyor
Figure 2-26. Long Hand-Feed Conveyor
Setup Procedure
1. Move the trimmer to the appropriate loca-
tion.
2. Remove (4) sets of screws and washers fas-
tened to the left side of the trimmer as
shown in Figure 2-27. Save them for later
use.
3. Make sure the reflector bracket is in place
as shown in Figure 2-27.
Figure 2-27. Hand Feed Mounting Hardware
4. Initially set the Hand-Feed Conveyor's level-
ing pads at approximately 2-1/4" (5.7 cm) as
shown in Figure 2-28
Figure 2-28. Hand-feed Leveling Pads
5. Move the Hand-Feed Conveyor to the left-
hand side of the trimmer such that the slots
in the conveyor mounting brackets line up
with the holes in the trimmer's left-hand side.
It may be necessary to adjust the Hand-
Feed Conveyor’s leveling pads in order for
the mounting brackets to line up properly.
6. Fasten the conveyor to the trimmer using
the hardware from step 2.
Cable Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
hand-feed conveyor near the input connect-
ors. The power cable has a 5-pin connect-
ors on the end.
2. Route the power cable under the hydraulic
unit and out of the left side of the trimmer.
3. Connect the power cable as shown in Figure
Figure 2-29. Power Cable Connection
Now go to Section 2.5 Trimmer Height Setup to
continue the setup process.
Summary of Contents for CMT-330TC
Page 4: ...APR 2018 CMT 330TC Three Knife Trimmer iv Introduction Notes...
Page 28: ...APR 2018 CMT 330TC Three Knife Trimmer 1 24 1 Introduction NOTES...
Page 60: ...APR 2018 CMT 330TC Three Knife Trimmer 3 12 3 Operator s Guide NOTES...
Page 72: ...APR 2018 CMT 330TC Three Knife Trimmer 4 12 4 Routine Tasks NOTES...
