APR 2018
CMT-330TC Three-Knife Trimmer
2-13
2. Installation Guide
2.6 Outfeed Setup
There are (3) available CMT-330TC outfeed op-
tions:
Option 1:
Vertical Outfeed Stacker
Option 2:
Exit Conveyor
Option 3:
Exit Ramp
Any of these options can be used regardless of
the trimmer configuration (in-line or stand-
alone).
The following procedures show how to setup
each of the 3 outfeed options.
2.6.1 Vertical Outfeed Stacker
Figure 2-31. Vertical Outfeed Stacker
Setup Procedure
1. Setup the outfeed stacker according to the
instruction and parts manual supplied with
the outfeed stacker.
2. Remove (2) sets of screws and washers
from the right side of the trimmer, just above
the power panel cover. Save them for later
use.
3. Move the Outfeed Stacker into position
against the trimmer, and adjust the leveling
feet of the stacker until the slots in the
stacker’s mounting brackets line up with the
holes in the side of the trimmer.
4. Fasten the Outfeed Stacker to the trimmer
using the hardware from step 2.
Cable and Air Tubing Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
outfeed stacker near the input connectors.
The power cables are the larger diameter
cables with 7-pin connectors on the end.
2. Route the power cable under the electrical
enclosure and out of the right side of the
trimmer.
3. Connect the power cable as shown in Figure
Figure 2-32. Power Cable Connection
4. Now locate the yellow communication cable
that is labelled with the number that corre-
sponds to the label on the outfeed stacker
near the input connectors. It is a small di-
ameter cable with a 3-pin connector on the
end. The cable will come from either the ele-
vator or pile feeder (if equipped), otherwise
from inside the trimmer.
5. Connect the communication cable as shown
Summary of Contents for CMT-330TC
Page 4: ...APR 2018 CMT 330TC Three Knife Trimmer iv Introduction Notes...
Page 28: ...APR 2018 CMT 330TC Three Knife Trimmer 1 24 1 Introduction NOTES...
Page 60: ...APR 2018 CMT 330TC Three Knife Trimmer 3 12 3 Operator s Guide NOTES...
Page 72: ...APR 2018 CMT 330TC Three Knife Trimmer 4 12 4 Routine Tasks NOTES...
