APR 2018
CMT-330TC Three-Knife Trimmer
4-2
4. Routine Tasks
4.1 Book Underside Air Lift
The book underside air lift uses a blast of air to
reduce scratching on the bottom cover as the
books moves through the machine. The amount
of lift may require adjustment depending on the
thickness of books being trimmed.
To adjust:
1. Locate the book underside air lift adjustment
knob as shown in Figure 4-1 below.
Figure 4-1. Underside Air Blast
2. Locate the red locking ring and unlock it by
pulling it toward you (away from the ma-
chine).
3. To increase the amount of lift, such as for
thicker books, adjust the valve counter-
clockwise.
4. To decrease the amount of lift, such as for
thinner books, adjust the valve clockwise.
5. When finished adjusting, push the locking
ring back in to lock it in place.
4.2 Waste Bins
The three waste bins may require emptying in
the middle of a shift, but it is a good idea to do it
before a shift begins. Sensors detect when a
waste bin is full. If any one of the three waste
bins become full during a job run, a message is
displayed on the screen stating which waste bin
is full. The trimmer will continue to run however.
Use the following procedure to empty waste
bins.
1. If running, stop the trimmer by pressing the
red stop button located next to the console
(Figure 4-2). It may be helpful to press the
stop button in between trimming cycles
since any books that are mid-cycle when the
machine is stopped will not be completely
trimmed and will be ejected at next startup.
Figure 4-2. Stop Button Location
2. Figure 4-3 and Figure 4-4 show the waste
bin locations. Internal waste models have
the bins located inside each door. External
waste models have the bins located just out-
side each door.
Figure 4-3. Waste Bin Locations
Summary of Contents for CMT-330TC
Page 4: ...APR 2018 CMT 330TC Three Knife Trimmer iv Introduction Notes...
Page 28: ...APR 2018 CMT 330TC Three Knife Trimmer 1 24 1 Introduction NOTES...
Page 60: ...APR 2018 CMT 330TC Three Knife Trimmer 3 12 3 Operator s Guide NOTES...
Page 72: ...APR 2018 CMT 330TC Three Knife Trimmer 4 12 4 Routine Tasks NOTES...
